NEWS
Position:HOME > NEWS > How to protect cut wire shot equipment

How to protect cut wire shot equipment

2021-09-09 10:38:15   Review:0 Click:
  When the cut wire shot equipment is put into production after device commissioning, it is necessary to strictly follow its necessary protection procedures.

  It is necessary to fill all oil filling points of cut wire shot equipment with engine oil, lubricating oil or grease regularly according to the requirements of their parts. It is necessary to check the seals every day and replace them immediately if they are damaged. Check the protective board of the chamber every day and replace it immediately if it is damaged. Inspect the guard plate, blade, impeller, directional sleeve and shot dividing wheel of shot blasting device twice per shift, and replace them immediately in case of damage.

  As an intermediate link or final process in the production process of cut wire shot mold, the cracking, deformation out of tolerance and function out of tolerance formed by heat treatment will invalidate the mold in most cases. Even after repair, it can still be used continuously. It will also add man hours, extend the delivery time and improve the manufacturing cost of the mold. Spraying is to use compressed air as power to spray sand or shot onto the material surface to achieve eradication and certain roughness.

An article:The steel shot after burning reaches the best service hardness
The next one:Four extraction methods of cast steel shot

<View all>
I'll say somethingAlready existing0Comment,Click to view all

REAGUAN
Tel:+86-317-5295077    Fax:+86-317-5295979   Email:sale@reaguan.cn Add:YiheBuilding,CangzhouCity,Hebei Province   Copyright © Hebei Reaguan International Co.,ltd.  Technical Support:boyikeji  Technical support: BOYIKEJI